If your Android device is not correctly detected by RAD Studio or the system Device Manager, follow the steps above to verify that USB debugging is enabled.įor general information about development setup for Android devices, see the Android documentation. If you accidentally click Cancel, disconnect your device from your PC and connect it back to make the dialog show up again on your device. that are Pending Approval and then adopt them on the UniFi Controller. If you are running Android 4.2.2 or later, you may see the following dialog when you connect your device to your PC running RAD Studio:Ĭlick OK to allow USB debugging on your PC.
For more information, see the Amazon documentation. Ive also tried to switch different USB mode on the Pixel to different options like PTP, charging only. Select Settings > Security and set Enable ADB to On. EDIT: OK, Ive tried using 2 different cables now to try and connect the phone to the laptop, one more USB-A to USB-C and a direct USB-C to USB-C connection, both sense the phone but no authorization popup to allow USB debugging on the Pixel. Tip: You might also want to enable the Stay awake option, to prevent your Android device from sleeping while plugged into the USB port.įor more information, see Unlocking Jelly Bean and Higher Devices Tap the Build number seven times to make Settings > Developer options available.On the device, go to Settings > About.The steps to enable USB debugging depend on the version of Android running on the target device, as indicated in the following table:Įnable the USB Debugging option under Settings > Developer options.įor Android 4.2 and newer, Developer options is hidden by default use the following steps:
0 kommentar(er)
